Polycom
1a. Reboot the phone to defaults by going to Menu > Settings > Advanced > PW: 456 > Admin Settings > Reset to Defaults > Reset local Config. This will reboot the phone.
1b. When the phone is back up, we next want to reset the 'device settings'. Go back to Menu > Settings > Advanced > PW: 456 > Admin Settings > Reset to Defaults > Reset Device Settings. This will reboot the phone again.
1. Follow steps 1a and 1b from above again.
2. After the phone finishes booting up. Go to Menu > Settings > Advanced (Password is 456) > Admin Settings > Network Configuration > DHCP menu > Set the 'Boot Server' to "static". Now back out one menu and select the 'Server Menu' field. On the next page, set the 'Server Type' to 'TFTP'. Set the 'Server Address' to 'IP.of.the.PBX/pc' (Example: 172.20.4.100)
2a. If the phone is remote connecting over a WAN, the 'Server Address' will be the WAN IP of the Switchvoxs network /pc (e.g. 173.227.12.32/pc).
3. Save your settings and reboot the phone.
4. When the phone finishes and completely boots up again,. you should be able to find the phone in the 'Unknown Phones' or the 'Unconfigured Section' of the Switchvox 'Phone Feature Packs'. Follow
step 2 or 3 (depending on where you found the phone MAC) at the top of this page to finish configuring the phone.
Yealink:
Go to settings>> Auto Provision >>Server Url: 172.20.4.100, username: admin, password: admin
